SPECIFICATIONS
Power Source:
1000-12V 12 Volt DC
1000-120V 120 Volt AC
60 HZ
Dimensions:
Length 20"
Depth 3.5"
Height 15.5"
Weight: 19 lbs
Flow Rate: 4 GPM
(US)
Maximum Pressure:
125 PSI
EASY INSTALLATION
Very simple to install. For maximum effectiveness,
you install as close to point of use as possible.
Simply break into water line and connect incoming
line to prefilter 1/2" NPT opening, then
connect "outflow" to other end of
water line. Plug the 120V into any grounded
120V outlet or wire the 12V to your 12V power
circuit. |
THE MODEL 1000
This model WaterFixer uses a 3 stage system that
delivers water at 4 gallons per minute.
STAGE 1 - A five
micron (5.0) prefilter removes particles larger
than 1/5000 of an inch in size.
STAGE 2 - A half
micron (0.5) filter removes fine sediment, odors,
unpleasant tastes, chlorine and other chemicals,
plus Cryptosporidium and Giardia cysts.
STAGE 3 - A Stainless
Steel Ultra-violet Light Exposure Chamber destroys
bacteria, viruses, protozoa, yeast, mold spores
and algae.
filter1000.jpg (22329 bytes)
No chemicals are used in our systems, there is:
NO WAITING....
The Model 1000 WaterFixer delivers water at 4
gallons per minute. This means you will experience
normal water flow.
NO WASTED WATER....
Since the WaterFixer does not require flushing
for water delivery, no water is wasted using the
WaterFixer system.
NO SEPARATE WATER TANK....
With the WaterFixer’s method of ultraviolet
sterilization, you receive clean, clear water
without the need of a separate holding tank.
NO DANGER FROM INFECTION....
Unlike reverse osmosis, the WaterFixer does not
store unprotected water. The ultraviolet chamber
kills germs which may grow in water tanks.
NO SPECIAL TOOLS....
Easy installation requires very little time and
common household tools.
WE CARRY ALL Filters and
Replacement parts.
|
