The Sanigrind unit discharges the effluent
through a 3/4-inch diameter pipe into a sanitary
gravity drain. Effluent can be pumped 18
feet or hoizontally to 150 feet, or a combination
of both. The unit is installed on the floor,
while the toilet, bath or shower, and handbasin
are situated on a raised platform.
The Sanigrind should be connected to a ground
fault circuit interrupter (GFCI) circuit
only. The supply is 120V, 15A single phase.
A micro-switch in the pressure chamber is
activated by the level of water in the unit
arising from the discharge of the sanitary
appliance. It will operate when the toilet
is flushed. Simple valves on each of the
side inlets close momentarily until the toilet
waste is reduced and pumped away. A non-return
valve prevents back flow into the unit.
The Sanigrind must only be used for human
waste and toilet tissue. It is however designed
to grind up other items that may accidentally
be flushed down the toilet such as strands
of wool, sanitary napkins, condoms, but not
dental floss, cat litter or disposable diapers,
nor is the Sanigrind to be used as a pump
for the kitchen sink.
Downloadable Techncial / Installation PDF
File
Adobe Acrobat is required to view this PDF
documents.
|
Dimensions:
Including Pump Only H12" x W18"
x D9" H30cm x W46cm x D23cm
Motor:
Induction Motor (no carbon brushes or gears),
tested over 50,000 cycles. 3600 rpm.
Electrical supply:
110-115V; 60Hz; 8.6 amps
Discharge:
Horizontally to 150 ft (50m) Pumps vertically
to 18 ft (6m)
Min. Gravity Fall on Horizontal installations:
1/4" per ft
Discharge Pipe Diameter:
3/4"; 21mm or 1"; 25mm
Construction Materials:
Polypropylene, C.R.P., stainless steel, Neoprene
Max. temp. 104°F; 4°C
Normal Running Time:
2–10 secs subject to installation pipe run
Water:
Volume 8.24 gal/m; 35 l/m
Designed to function with:
Toilet, Hand-basin, Shower, Bathtub or Washing
Machine (must drain into laundry sink first)
|
